| Most viewed |
420 viewsBased on David Steele's plans at solsylva.com my router has a 25"x 25" working area.
|
|
402 viewsGantry end plate and X leadscrew.
|
|
388 viewsX leadscrew pulley.
|
|
366 viewsSkate bearings. $30 per 100 on eBay.
|
|
354 viewsGantry with oak end plates. Screen door springs used as wire supports. Z carriage is oak too (black piece the trim router mounts to). Bed is 1/2" birch plywood, lighter and stiffer than MDF.
|
|
317 viewsScreen door springs used as wire supports.
|
|
305 viewsPower supplies. Front is 5 & 12 VDC for the breakout board. Rear is 48VDC for drivers.
|
|
298 viewsX belt idler pulley.
|
|
297 viewsZ carriage plate (black router mount) made of oak for strength.
|
|
291 viewsCPU cooler attached to back of the Gecko mounting plate.
|
|
288 viewsPorter Cable trim router with 1/4" collet.
|
|
288 viewsY leadscrew.
|
|
285 viewsZ carriage plate (black router mount) made of oak for strength.
|
|
282 viewsBack of gantry.
|
|
278 viewsGecko G203V drivers make this router achieve 70 ipm rapids with 5/8-16 leadscrews. Mounted to a 1/8" thick aluminum plate for heat sinking. Love these Geckos!
|
|
275 viewsX stepper.
|
|
|
|
